High-speed cutting machine What to pay attention to when using:
1. The power cord of the cutting machine should be connected to a ground wire, otherwise the static electricity will hurt the staff;
2, the lubrication machine should be lubricated with lubricating oil before starting. . Then check to tighten the loose screws and the corresponding equipment, and then let go of the moisture in the gas path;
3, the productivity of the cutting machine is commonly used 220 volts Current and some compressed gas, so the corresponding power switch and air pressure switch must be turned on before starting the production and production;
4, it must be automatically adjusted before the maintenance The function is turned off to prevent damage to the machine or injury to the staff. If the automatic switch is not turned off, then the accidental stepping on the foot switch causes the machine to start, the consequences are unimaginable.
5, the pressure of the cutting machine can be adjusted: the pressure of the cutting machine is too large, which may damage the terminal of the wire. If the pressure is too small, the terminal will be from the wire conductor. Slip off. Adjustment method: Loosen the three screws on the front of the slider, slide the adjustment screw of the slider head clockwise to increase the pressure, and then lock the three screws on the front of the slider, which will reduce the pressure; /p>
6. If you find that the wire position of each wire is unstable after moving the wire of the wire cutting machine to a position, it means that the track transmission speed of the wire cutting machine is too fast. The transmission speed of the track can be lowered by loosening the lock nut of the speed valve on the cylinder, rotating the speed control valve stem clockwise to reduce the speed, and counterclockwise rotation will increase the speed and adjust the speed to a suitable speed. To lock the nut;
7. If you find that the wires are moved to a position, they are all left or right, then you have to loosen the main sprocket. The three screws are modified. The modification method is to open the air source by back-linking the air pipe of the cylinder that drives the crawler, and pull the crawler to place the plastic sub-groove of the wire card in the middle position of the rivet, and clear the gap between the ratchet and the pawl of the push crawler. Then, fix the three screws and adjust the direction of the air pipe to achieve the purpose of adjustment.
